Show simple item record

dc.contributor.advisorBarrett-Gonzalez, Ronald
dc.contributor.authorBarnhart, Ryan
dc.date.accessioned2013-01-20T15:05:34Z
dc.date.available2013-01-20T15:05:34Z
dc.date.issued2012-12-31
dc.date.submitted2012
dc.identifier.otherhttp://dissertations.umi.com/ku:12415
dc.identifier.urihttp://hdl.handle.net/1808/10625
dc.description.abstractThis document outlines the design, development and testing of an adaptive flutter test surface utilizing low net passive stiffness (LNPS) actuator configurations for deflection amplification. The device uses a tapered piezoelectric bender actuator in an aerodynamic shell which pivots about the quarter-chord. Laminated plate theory is used to capture the unamplified deflection levels. A unique reverse-bias spring mechanism enables LNPS techniques, generating a 5:1 amplification ratio from baseline deflection levels with negligible weight penalty and no degradation in blocked moments. The adaptive flutter test vane and associated spar-mounting hardware have a combined weight of only 2 lb and consume less than 1W of peak power at maximum actuation voltage. The significance of the relatively low installed weight is apparent when considering the effect on the modal mass of the aircraft. It can be shown that a reduction in weight from the current state-of-the-art 18+ lb (installed) DEI vane to a 2 lb adaptive flutter test vane (installed) improves the normalized first natural frequency of flap in a wing from approximately 60% to 90% in light aircraft classes - all but eliminating the detrimental effect of additional mass on the accuracy of flutter prediction. Quasi-static and dynamic wind tunnel testing shows excellent correlation with bench tests and theory. Maximum deflection levels were recorded in excess of 8 deg. peak-to-peak, with a corner frequency in excess of 50 Hz. Wind tunnel tests were performed up to 110 ft/s with change in lift forces on the order of 1.45 lbf. This paper focuses on the testing and evaluation of the aforementioned hardware for applications in certification of small aircraft in the general aviation (GA), light sport (LSA), homebuilt and ultralight classes.
dc.format.extent168 pages
dc.language.isoen
dc.publisherUniversity of Kansas
dc.rightsThis item is protected by copyright and unless otherwise specified the copyright of this thesis/dissertation is held by the author.
dc.subjectAerospace engineering
dc.subjectActuator
dc.subjectDeflection amplification
dc.subjectFlutter testing
dc.subjectLnps
dc.subjectLow net passive stiffness
dc.subjectPiezoelectric
dc.titleAdaptive Flutter Test Vane: Low Net Passive Stiffness (LNPS) Techniques for Deflection Amplification of Piezoelectric Actuators
dc.typeThesis
dc.contributor.cmtememberEwing, Mark
dc.contributor.cmtememberKeshmiri, Shahriar
dc.thesis.degreeDisciplineAerospace Engineering
dc.thesis.degreeLevelM.S.
kusw.oastatusna
kusw.oapolicyThis item does not meet KU Open Access policy criteria.
kusw.bibid8085586
dc.rights.accessrightsopenAccess


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record