Investigation of Variations in Corrosion Potential in Mechanically Stabilized Earth Backfill Due to Migration of Fines
Issue Date
2019-05-31Author
Breckwoldt, Chase Vincent
Publisher
University of Kansas
Format
88 pages
Type
Thesis
Degree Level
M.S.
Discipline
Civil, Environmental & Architectural Engineering
Rights
Copyright held by the author.
Metadata
Show full item recordAbstract
Departments of transportation have constructed thousands of mechanically stabilized earth (MSE) walls to support bridge abutments in highway projects and for other applications. These MSE walls often include metal strips or grids as reinforcement, typically galvanized steel strips within granular backfill meeting Federal Highway Administration (FHWA) and American Association of State Highway and Transportation Officials (AASHTO) standards. Utilization of steel strips or grids creates a stronger composite material; however, minerals within the backfill or salts applied at the surface can create a corrosive environment. Excessive corrosion can lead to distresses or premature failure of MSE structures. Corrosion may increase when cycles of water from precipitation promote migration of fines through the granular backfill. Migrating fines have the potential to accumulate at the base of the reinforced fill and clog drainage and retain water, which could accelerate the corrosion process. This study evaluated the potential for accelerated corrosion due to the accumulation of fines with water. Aggregate approved for use in MSE structures was placed in a test column with internal dimensions of 183 by 30 by 30 cm and flowing water through it. The grain size distribution was measured at different elevations within the column and the resistivity of the aggregate, which is correlated with corrosion rate, was also evaluated at a series of elevations within the column after passing water through the column. Results from the testing were compared with resistivity results from a test box consistent with current Kansas Department of Transportation (KDOT) use. All aggregates tested had a drained resistivity that was above the 3000 or 5000-ohm centimeter (ohm-cm) minimum. The results of this study show that migration of fines occur in KDOT aggregates, and that this migration can cause measurable changes in the grain size distribution, water content, and resistivity of the soil column. In addition, as the number of saturated and drained cycles increases for each material, the resistivity increases. The current KDOT specification limiting the amount of material passing the No. 200 sieve is beneficial in that it limits the fines available for migration. Additional constraints within the specification could further limit the potential for suffusion.
Collections
- Engineering Dissertations and Theses [1055]
- Theses [3944]
Items in KU ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.
We want to hear from you! Please share your stories about how Open Access to this item benefits YOU.