Yarlagadda, VenkataLin, GuangyuChong, Pau YingVan Nguyen, Trung2016-04-012016-04-012015-10-30Yarlagadda, Venkata, Guangyu Lin, Pau Ying Chong, and Trung Van Nguyen. "High Active Surface Area and Durable Multi-Wall Carbon Nanotube-Based Electrodes for the Bromine Reactions in H 2 -Br 2 Fuel Cells." Journal of The Electrochemical Society J. Electrochem. Soc. 163.1 (2015): n. pag. doi:10.1149/2.0181601jeshttps://hdl.handle.net/1808/20620The commercially available carbon gas diffusion electrodes (GDEs) with low specific active area but high permeability are often used as Br2 electrodes in the H2-Br2 fuel cell. In order to increase the specific active surface area of the existing carbon GDEs, a study was conducted to grow multi-wall carbon nanotubes (MWCNTs) directly on the surface of carbon fibers of a commercial carbon electrode. Experimental fixtures were developed to promote the electrodeposition of cobalt and the growth of MWCNTs on the carbon GDE. The MWCNT growth across the carbon electrode was confirmed by SEM. The carbon GDE with a dense distribution of short MWCNTs evaluated in a H2-Br2 fuel cell has 29 times higher active surface area than a plain carbon electrode and was found to be highly durable at an electrolyte flow rate of 10 cc/min/cm2. The performance of the best single layer MWCNT GDE measured at 80% discharge voltage efficiency in a H2-Br2 fuel cell was found to be 16% higher compared to that obtained using three layers of plain carbon electrodes. Finally, the preliminary material cost analysis has shown that the MWCNT-based carbon electrodes offer significant cost advantages over the plain carbon electrodes.This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 License (CC BY, http://creativecommons.org/licenses/by/4.0/), which permits unrestricted reuse of the work in any medium, provided the original work is properly cited.http://creativecommons.org/licenses/by/4.0/Carbon nanotubesFlow batteriesFuel cellsHydrogen-bromineKinetic and transport effectHigh Active Surface Area and Durable Multi-Wall Carbon Nanotube-Based Electrodes for the Bromine Reactions in H2-Br2 Fuel CellsArticle10.1149/2.0181601jeshttps://orcid.org/0000-0003-4544-066XopenAccess